From 6d6253ef126e8e3def616eab5e05c0bf8ef46b9b Mon Sep 17 00:00:00 2001
From: mathieu2em <math.per@hotmail.com>
Date: Tue, 20 Aug 2019 15:25:51 -0400
Subject: correcting the typos detected in revision by Mr Jao

---
 INSTALL | 27 +++++++++++++--------------
 1 file changed, 13 insertions(+), 14 deletions(-)

(limited to 'INSTALL')

diff --git a/INSTALL b/INSTALL
index 7c4f241..1059da0 100644
--- a/INSTALL
+++ b/INSTALL
@@ -65,11 +65,10 @@ package-install-file.
 * Gambit Addendum
   These steps are necessary to fully support all Gambit Scheme functionnalities,
   but are not required for any other scheme.
-   
-   
-  # SETUP :                                  
-    1 - clone the last version of gambit and of this repo                                       
-    2 - configure gambit using --enable-rtlib-debuf-source to activate autodoc
+
+  # SETUP :
+    1 - clone the last version of gambit and of this repo
+    2 - configure gambit using --enable-rtlib-debug-source to activate autodoc
     ``` bash
     $ cd ~/
     $ git clone "the gambit repo address"
@@ -80,34 +79,34 @@ package-install-file.
     $ make -j
     $ make install
     ```
-    3 - put a link to geiser/elisp/geiser.el in your init file 
-    in your init file paste : 
+    3 - put a link to geiser/elisp/geiser.el in your init file
+    in your init file paste :
     ``` elisp
     (load-file "~/geiser/elisp/geiser.el")
     ```
     (the path is your path to geiser.el.)
-   
+
   # setup REMOTE CONNECT TO A GAMBIT REPL
     1 - you need to enable the gambit/geiser module
     ( if you can't,  substitute the command below
-      with the PS: at the end of the readme ) 
+      with the PS: at the end of the readme )
     ``` bash
     $ mkdir ~/gambit/lib/gambit/geiser
     $ cp ~/geiser/geiser-module/* ~/gambit/lib/geiser/
     ```
-    2 - now that you have the module you start gsi with it and using the -:d@ 
+    2 - now that you have the module you start gsi with it and using the -:d@
     ``` bash
     $ gsi -:d gambit/geiser -
     ```
-    3 - you can now open emacs and write 
+    3 - you can now open emacs and write
     ```
     M-x geiser-connect gambit
     ```
   Enjoy !
 
-PS:
-if you are unable to use gambit modules , open gsi with the gambit.scm file 
-located in geiser/scheme/gambit/geiser/gambit.scm 
+By the way, if you are unable to use gambit modules,
+open gsi with the gambit.scm file
+located in geiser/scheme/gambit/geiser/gambit.scm
 
 something like : gsi -:d@ ~/geiser/scheme/gambit/geiser/gambit.scm -
 
-- 
cgit v1.2.3